Magnum-energy ME-MR Remote Manual de usuario

Owner’s Manual(for Revision 1.1 or higher)ME-MRRemote Control

4 ©2013 Magnum Energy, Inc.2.0 Installation Figure 2-3, Remote Control ConnectionsBACKRJ11 ConnectionMagnum InverterRemote CableRemote Port (blue)2.2

©2013 Magnum Energy, Inc. 53.0 Setup3.0 SetupWhen the ME-MR remote is connected to a Magnum inverter/charger, the remote’s settings determine the inv

6 ©2013 Magnum Energy, Inc.3.0 Setup 3.2 Remote Menu ItemsThis section covers the function of each menu item and explains what con-fi gurable setting

©2013 Magnum Energy, Inc. 73.0 SetupFigure 3-3, Search Watts SelectionsBottom line shows current “saved” settingIf this setting is correct, press ME

8 ©2013 Magnum Energy, Inc.3.0 Setup 3.2.3 Battery Amp-Hours Menu• BAT AHRS – This selection is used to select the approximate capacity of the batte

©2013 Magnum Energy, Inc. 93.0 SetupTable 3-2, Battery Size to Battery Amp-Hours (estimated)Group/Code SizePhysical Size(L” x W” X H”)BatteryVoltageB

10 ©2013 Magnum Energy, Inc.3.0 Setup 3.2.4 Battery Type Menu• BAT TYPE – This menu is used to select the battery type, which determines the battery

©2013 Magnum Energy, Inc. 113.0 Setup3.2.5 Charge Rate Menu• CHG RATE – This selection is used to set the maximum charge rate allowed to charge the

12 ©2013 Magnum Energy, Inc.3.0 Setup 3.2.6 Low Battery Cut-Out (LBCO) Menu• LBCO – This menu is used to set the DC voltage level that turns off the

©2013 Magnum Energy, Inc. 133.0 Setup3.2.7 VAC Dropout Menu• VAC DROP – This selection is used to set the minimum AC voltage that must be present on

Disclaimer of LiabilityThe use of this manual and the conditions or methods of installation, operation, use, and maintenance of the ME-MR remote are b

14 ©2013 Magnum Energy, Inc.3.0 Setup If you have a fault during the Power Saver mode, the LCD backlight, and the FAULT LED will come on and stay on

©2013 Magnum Energy, Inc. 153.0 Setup3.2.10 Charger Standby Menu• CHARGER – Select whether to activate Charger Standby mode after AC power is connect

16 ©2013 Magnum Energy, Inc.3.0 Setup 3.2.12 TECH Menu• TECH – This menu provides access to read only system information that can assist service tech

©2013 Magnum Energy, Inc. 173.0 SetupTable 3-4, ME-MR’s Inverter/Charger Default SettingsMenu Default SettingAC In AC IN = 30 AmpsSearch Watts SEARC

18 ©2013 Magnum Energy, Inc.4.0 Menu MapFigure 4-1, ME-MR Remote Menu Map4.0 Menu Map: ME-MR Remote ControlThis menu map is an overview of the inver

©2013 Magnum Energy, Inc. 195.0 Operation5.0 OperationThis section gives a brief overview of the ME-MR remote’s LED indicators, LCD display, and avai

20 ©2013 Magnum Energy, Inc.5.0 OperationCHANGE ButtonThis button scrolls through the selections available under each menu heading. Each menu restart

©2013 Magnum Energy, Inc. 215.0 OperationWARNING: Do not perform an equalization charge without reading and following all safety precautions pertaini

22 ©2013 Magnum Energy, Inc.5.0 Operation5.3.2 Charger Mode MessagesWhen AC power (utility or generator) is connected to the inverter/charger, it be

©2013 Magnum Energy, Inc. 235.0 OperationBulk appears on the LCD. The FAULT (red) LED is off, and the INV (green) LED could be on or off. STATUS Bu

©2013 Magnum Energy, Inc. iiImportant Product Safety InstructionsThis manual contains safety instructions that must be followed during the installati

24 ©2013 Magnum Energy, Inc.5.0 Operation• Equalizing Mode – The battery charger is delivering the equalize voltage to the batteries. Refer to Tabl

©2013 Magnum Energy, Inc. 255.0 Operation• Float Charging Mode – At the end of the Absorb Charging stage, the charger reduces the charge voltage and

26 ©2013 Magnum Energy, Inc.5.0 Operation• Unknown Mode XX – The remote doesn’t recognize the mode the inverter is reporting. Contact Magnum Technica

©2013 Magnum Energy, Inc. 275.0 Operation5.3.3 Fault Mode MessagesWhen an abnormal condition is detected, the FAULT LED comes on and a fault status

28 ©2013 Magnum Energy, Inc.5.0 OperationFAULT !FetOvrldFetOvrld appears on the LCD and the FAULT (red) LED is on. The INV (green) LED is off.Figure

©2013 Magnum Energy, Inc. 295.0 Operation• FET Overload Fault – The inverter/charger has shut down because the internal FETs (Field Effect Transistor

30 ©2013 Magnum Energy, Inc.5.0 OperationLow Batt appears on the LCD and the FAULT (red) LED is on. The INV (green) LED is off.Figure 5-24, Low Batte

©2013 Magnum Energy, Inc. 315.0 Operation• DC Overload Fault – The inverter shuts down to protect internal power components from an excessive AC loa

32 ©2013 Magnum Energy, Inc.5.0 Operation• Unknown Fault – When a number appears in the second line of the remote it means the remote doesn’t know wh

©2013 Magnum Energy, Inc. 335.0 Operation5.3.3.2 Stacking Fault MessagesA fault condition may occur when multiple inverters are connected together (

iii ©2013 Magnum Energy, Inc.Table of Contents1.0 Introduction ...12.0 Installation ...

34 ©2013 Magnum Energy, Inc.5.0 OperationFAULT ! BridgeBridge appears on the LCD and the FAULT (red) LED is on. The INV (green) LED is off.Figure 5-3

©2013 Magnum Energy, Inc. 355.0 OperationLED Status MeaningINV (green)OFF1. Inverter is disabled; or 2. Remote is in Power Saver mode – press any but

36 ©2013 Magnum Energy, Inc.6.0 Troubleshooting6.0 TroubleshootingIf the remote is not functioning correctly, use the following table to help fi nd a

©2013 Magnum Energy, Inc. 376.0 Troubleshooting6.1 Troubleshooting Tips6.1.1 Inverter Problems:• Inverter turned on, the INV LED on the remote is bl

38 ©2013 Magnum Energy, Inc.6.0 Troubleshooting6.3 Performing a Power ResetTo perform a power reset (i.e., hard reset):1. Remove all AC power (util

©2013 Magnum Energy, Inc. 397.0 Warranty and Service Info7.0 Warranty and Service Information7.1 Limited WarrantyMagnum Energy, Inc., (hereafter “Ma

40 ©2013 Magnum Energy, Inc.7.0 Warranty and Service Info7.1.1 How to Receive Repair ServiceIf your product requires warranty service or repair, cont

Magnum Energy, Inc.2211 West Casino Rd.Everett, WA 98204Phone: (425) 353-8833Fax: (425) 353-8390Web: www.magnumenergy.comPN: 64-0031 Rev D

©2013 Magnum Energy, Inc. ivList of FiguresFigure 1-1, Front Panel Features ... 1Figure 2-1, C

v ©2013 Magnum Energy, Inc.List of TablesTable 3-1, Battery Amp-Hrs to Absorb Charging Time ... 8Table 3-2, Battery Size to

©2013 Magnum Energy, Inc. 11.0 Introduction1.0 IntroductionThe ME-MR remote control allows you to monitor and customize the basic operating parameter

2 ©2013 Magnum Energy, Inc.2.0 Installation 2.0 InstallationReview the Important Safety Instructions on page ii before proceeding with the installati

©2013 Magnum Energy, Inc. 32.0 InstallationFigure 2-1, Cut-Out Dimensions for Flush Mounted RemoteFigure 2-2, Bezel Dimensions for Surface Mounted Re