Magnum Energy ME-RC Manual del operador descargar pdf (Pagina 10)

 2003 - Magnum Energy, Inc.

LEDs

The remote contains the following LEDs to indicate various

modes of operation.

POWER –

The green POWER LED indicates 120 VAC power is available

at HOT OUT 1 and HOT OUT 2 from either inverting, shore or

generator power.

FAULT –

The red FAULT LED indicates the inverter/charger has shut

down from one of the following conditions:

• High Battery - Battery voltage exceeded 15.5 VDC

• Low Battery – Battery voltage is below LBCO setting

• Overtemp – Unit has exceeded maximum operating

temperature

• AC Overload – AC loads exceeded unit’s output rating

CHARGER –

The green CHARGER LED indicates the charger is “ON.” The

charger’s output is determined by selections made in the

“Charge Rate” and “Shore” setup options. When the

CHARGER LED is blinking, it indicates a “reduced charge

rate” based on a low “Charge Rate” or “Shore” setting, or an

over temperature condition.

INVERTER –

The green INVERTER LED indicates the inverter is “ON.” If

AC power is available from shore or generator, then the

inverter is in “standby mode” indicated by a blinking LED.

In the event AC shore or generator power is lost, the in-

verter is standing by to power the connected loads from the

batteries.

3. Operation, continued

Figure 3

LEDs

Power LED

Fault LED

Charger LED

Inverter LED

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Magnum Energy ME-RC Manual del operador Pagina 10