Magnum Energy M-RC Manual del operador descargar pdf (Pagina 5)

 2004 - Magnum Energy, Inc.

2. Configuration

Figure 1 - AGS Controller Configuration

(DIESEL/GAS and 12/24 V DC Operation)

1. Configuring the AGS Controller

The Magnum AGS Controller can be configured for 12 or 24 VDC

operation. It can also be configured for various diesel or gas

generator brands and models. The controllers default settings

are set for "12 VDC" and "Diesel" operation. If necessary, refer

to Table 1 (next page) to determine which setting is correct for

your system. To access the jumpers, remove the controllers

four cover screws.

For Onan Quiet Diesel generators, the controller is configured

with the "Diesel/Gas" jumper positioned over the two

left-hand pins as shown below (factory default).

For most "gas" as well as other diesel generators you must

configure the controller with the "Diesel/Gas" jumper

positioned over the two right-hand pins as shown below

For 12 Volt DC operation, the controller is configured

with the "12/24 V" jumper positioned over the two left-hand

pins as shown below (factory default).

For 24 Volt DC operation, you must configure the

controller with the "12/24 V" jumper positioned over the two

right-hand pins as shown below.

Onan Quiet Diesel

(default)

Other Diesel

and Gas

Controller and Internal Board

Remove the four

cover screws

12/24 V

Jumper

12 VDC Operation

(default)

24 VDC Operation

DIESEL/GAS

Jumper

Not Used

1 2 3 4 5 6 7 8 9 10 ... 19 20

Sin comentarios

Magnum Energy M-RC Manual del operador Pagina 5