Magnum Energy M-RC Manual del operador descargar pdf (Pagina 9)

 2004 - Magnum Energy, Inc.

3. Installation

4. Plug the other end of the 6 wire phone cable into the AGS

Controllers RJ-11 connector marked "Remote."

5. If all wiring is correct, the unit performs a "self test" when

power is applied. The "STATUS" LED blinks green. At the

same time, the "READY" LED turns on solid green.

6. Reconnect the generators spark plug (or reconnect the

battery for diesel generators).

4-wire Cable w/Temperature Sensor Installation (option)

1. The sensor is normally located behind the wall thermostat

(on the mounting plate) or next to the thermostat remote

sensor (installed by the OEM). These are the two most common

and recommended mounting locations.

NOTE: The thermistor that is used to sense the coachs interior

temperature is located at the very tip of the sensor cable. It is

vital that the sensor be placed where interior room tempera-

tures can be accurately monitored by the thermistor. Keep the

switch away from heating and air conditioning ducts, window

drafts and avoid mounting it on the coachs exterior walls.

Interior walls and cabinets provide much more stable tempera-

tures and make it easier to route the cable to the Controller.

2. Plug the other end of the 4 wire phone cable into the AGS

Controllers RJ-11 connector marked "REMOTE."

3. If all wiring is correct, the system performs a "self test"

when power is applied. The controllers "STATUS" LED blinks

green. At the same time, the "READY" LED turns on solid

green. If the remote is not connected, the controllers

"READY" LED blinks green. Installation is now complete.

4. Reconnect the generators spark plug (or reconnect the

battery for diesel generators).

Direct Connection to A/C Thermostat (option)

NOTE: OEM installation only. Contact factory for questions

regarding this feature.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

Magnum Energy M-RC Manual del operador Pagina 9