Magnum Energy M-RC Manual del operador descargar pdf (Pagina 8)

 2004 - Magnum Energy, Inc.

3. Installation

Installing the AGS Interior Temperature Sensor

WARNING: Always check for hidden wires, pipes and

cables before drilling or cutting into the

coachs walls and cabinets.

There are three options for installing the AGS Interior Tempera-

ture Sensor which are all used in conjunction with the ME-RC

remote control. You must specify which option you would like

when ordering your Magnum AGS system or call the factory to

order if your system did not come with the desired option.

1) a wall-mount switch with integrated temperature sensor;

2) a 4 wire cable with temperature sensor (OEM Installs only);

3) a direct connection to the a/c thermostat via a 2 wire pigtail

assembly (OEM Installs only).

AGS Wall Switch Installation (option)

1. Locate a convenient spot to mount the AGS Switch. The side

wall of the coachs refrigerator enclosure is the most common

(and recommended). The switch should be mounted midway

up the wall for best results.

NOTE: The thermistor that is used to sense the coachs interior

temperature is located on the back of the AGS Switch. It is

vital that the switch be placed where interior room tempera-

tures can be accurately sensed by the thermistor. Keep the

sensor away from heating and air conditioning ducts, window

drafts and avoid mounting it on the coachs exterior walls.

Interior walls and cabinets provide much more stable tempera-

tures and also make it easier to route the switchs cable to the

AGS Controller.

2. Use the template at the rear of the manual to cut a hole for

the AGS Switch. Feed the 6 wire phone cable through the

opening and route it to the AGS Controller. Use care in

routing the cable to insure the cable does not become

pinched or cut by rough or sharp edges. Leave enough slack

to allow cable movement once the installation is complete.

3. Make sure the switch is the "OFF" position and then plug the

cable into the RJ-11 phone connector on the back of the AGS

Switch. Mount the switch to the wall using the two 6x1

screws provided.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sin comentarios

Magnum Energy M-RC Manual del operador Pagina 8