Magnum Energy M-RC Manual del operador descargar pdf (Pagina 7)

 2004 - Magnum Energy, Inc.

3. Installation

Installing the AGS Controller

In most cases, the Auto Gen Start (AGS) Network System with

Inverter and Remote has been installed by the coach manufac-

turer.

1. Determine a suitable location to mount the Auto Gen Start

(AGS) Controller. It must be located in a clean, dry and

protected place.

The controller can be mounted in any direction; however,

allow ample room to access the adjustment dials and to view

the LEDs for troubleshooting. Wiring is much easier if the

controller is mounted within easy access to the generators

remote wiring. Pre-drill the four 1/8 holes if necessary.

2. Remove the 8 pin connector from the controller by pulling it

straight out. Wire the controller according to Figures 3 and

4 (see pages 8 and 9).

3. Use the four 8x3/4 screws (provided) to mount the

controller to the coachs wall.

4. When all of the wiring is complete, plug the 8 pin connector

back into the AGS controller.

5. Connect the AGS Controllers "NETWORK" port to the

inverters "NETWORK" port using the 4 wire twisted pair

cable.

Figure 2 - AGS Controller, Sensor and Remote

Controller

Remote

Sensor Cable

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Sin comentarios

Magnum Energy M-RC Manual del operador Pagina 7